Diamond tile dry core drill bit, 1/4 inch, hexagon shank
CREBIT-DRY-DIA-TILES-HEX-E-L80-WL40-D8
Art.-no. 5457230008
EAN 4053479430355
Register now and access more than 125,000 products
Quick drilling
due to vacuum diamond coating
With special cooling wax
When drilling for more than 30 seconds, take short breaks to allow the drill bit to cool down.
Standard ¼-inch hexagonal shank, shape E
- No slippage in the drill chuck
- Suitable for any bit mount
- No water necessary!
- Speed regulation not necessary.
- The drill bits are approximately 0.5 to 1 mm longer than required. This makes it easier to drill further into the base material (e.g. a stone drill bit), preventing damage to the tile.
Datasheets(X)
- Particularly suitable for tiles and stoneware with a thickness of up to 15 mm. Thicker materials up to the specified working length can still be drilled, but more frequent breaks will be needed to allow the drill bit to cool down.
- Suitable for hard ceramic, thin granite and marble panels and hard-baked bricks.
- Spot drilling: Hold at an angle when the bit is moving, then gradually move it to a perpendicular position.
- Light circular movements increase the drilling speed and preserve the core bits.
- Note: When drilling for more than 30 seconds or when drilling through thick materials, take short breaks to allow the drill bit to cool down.
- Regular breaks to allow the drill bit to cool down generally increase the service life of the core drill bits.
- Only use drill bits in rotating mode!
- Use powerful drill. Minimum rotation speed 1000 rpm (higher speeds significantly shorten the drilling time and extend the service life of the core bit) and a minimum of 12 V for cordless tools.
- Always use suitable protective equipment.
Versatility (points system) | 2 of 4 points |
Service life (points system) | 3 of 4 points |
Drilling speed (point system) | 2 of 4 points |
Bore hole quality (point system) | 2 of 4 points |
Drilling pattern (points system) | 2 of 4 points |
Problem solver (points system) | 3 of 4 points |
Diameter (Ø) | 8 mm |
Working length | 40 mm |
Length | 80 mm |
Last viewed
Pan head screw with H cross recess DIN 7985, steel 4.8, zinc-plated, blue passivated (A2K)
Hexagon Socket Head Cap Screw ISO 4762/DIN 912, steel 12.9, plain
Hexagon Socket Head Cap Screw ISO 4762/DIN 912, steel 12.9, plain
Plastic plug-in connectors
Ratcheting combination wrench set, multi profile 6 pcs
PLUG-IN CONNECTORS MALE THREAD
Twist drill bit HSS DIN 338 type RN 130°
Hexagon nut with fine thread DIN 934, steel I8I, zinc-plated, blue passivated (A2K)
Twist drill bit HSS DIN 338 type RN 130°
Twist drill bit HSS DIN 338 TYPE RN