Die stocks DIN 225
Threading die holder DIN 225
HOLD-THRDIE-DIN225-SZ2-(M5-M6)
Register now and access more than 125,000 products
Durable design and secure fastening
Housing made of die-cast zinc with knurled clamping screws and 90° tip for mounting die.
The die is placed in the die holder at the height of the middle screw. The screws are tightened with a screwdriver. The die is placed vertically on the workpiece. Can be used on both sides. When cutting, sufficient cutting oil must be added. After two revolutions, the cut can be broken by briefly turning back.
Material | Malleable cast iron |
Internal diameter x height | 20 x 7 mm |
Datasheets (0)
Certificates/ Documents (0)
Last viewed
1/2 inch socket wrench insert, metric
Fast grinding polish P10 Plus
LI-ION BATTERY PACK 12.0V / 2.0Ah CLASSIC
Gas filter ABEK1 For breathing protection series 175
Metric combination wrench with POWERDRIV®
S1 shoe with composite
1/2 inch torque wrench
1/2" socket wrench insert For TX screws, short
FLAP DISC CERAMIC FOR STAINLESS STEEL
Spacer washer
